Silicone Heat Resistant Sheen Black
Reference No.: 17-57
Silicone resin coating type, typically used as a heat resistant coating for use at temperatures up to 400°C.
| Colours available: | Black |
| Appearance Of Dried Film: | Low sheen |
| Volume Solids: | 35% |
| Dry Film Thickness: | Typical 25 microns |
| Theoretical Coverage: | 14.0m² per litre at 25 microns dry film thickness |
| Drying Time At 20°C: | Touch Dry: 10 minutes Film Dry: 1 hour Overcoat: After 1 hour (will vary with temperature, air movements, etc.) Note: A heat cure at 250°C for about 1 hour is required to produce a heat resistant finish |
| Packaging: | 5 litre containers |
| Shelf Life: | 2 years or longer in unopened containers when stored under cover in good storage conditions. |
| Storage: | Under cover with temperature range of 5°C to 32°C |
| Surface Preparation: | Abrasive blast to ISO 8501-1 SA2.5 is the preferred method. Clean, mild steel, free of millscale or rust, should be thoroughly degreased with Dacrylate Thinner R5. |
| Application: | Apply by conventional spray to a wet film thickness of approximately 70 microns to achieve a dry film thickness of 25 microns. |
| Clean-up: | Dacrylate Thinner R5 |
| Health and Safety: | For more information request relevant Material Safety Datasheet. |
The above information is general information on the product but without warranty. Since conditions of service and application are beyond our control we cannot accept claims for loss, damage etc., based on this information. Dacrylate will not accept any claim for consequential or incidental damages.
