Dacrylate Paints Ltd.

High Performance Coating Solutions

Dacrylate High Performance Metal Coatings
Solvent Borne Acrylic Vinyl Sheen Finish

Solvent Borne Acrylic Vinyl Sheen Finish

Reference No.: 47-Line

High build acrylic vinyl pigmented with durable, light-fast pigments offering excellent durability and colour retention properties.

High build coating for protection of steel and galvanised steel, including lighting columns, street furniture, metal fencing plus general industrial plant. Also suitable for application to Plastisol cladding and other such substrates.

Colours available: Full range to special order, contact us for more details.
Appearance Of Dried Film: Sheen
Volume Solids: 40% (may vary with colour)
Dry Film Thickness: Typical 75 microns
Theoretical Coverage: 5.3m² per litre at 75 microns
Drying Time At 20°C: Touch Dry: 1 hour
Film Dry: 3 hours
Overcoat: 3 hours
(will vary with temperature, air movements, etc.)
Packaging: 5 litre containers
Shelf Life: 12 months in unopened containers when stored under cover in good storage conditions.
Storage: Under cover with temperature range of 5°C to 32°C.
Surface Preparation: Mild steel, clean and free of millscale: Thoroughly degrease using Dacrylate Thinner R5. Normally applied over Dacrylate Epidac 2 Epoxy Primers, Vinadac Red Oxide (Ref.: 41-419).
Mild steel, corroded and/or millscale present: Abrasive blasting to ISO 8501-1 SA 2.5 is the preferred method.
Manual clean: Chip, scrape and power wire brush to remove all loose rust, millscale, etc., to ISO 8501-1, ST3. Degrease with Dacrylate Thinner R5. Apply one coat of Dacrylate Epidac 2 Epoxy Primers, Vinadac Red Oxide (Ref.: 41-419).
Galvanising (new): Ensure surface is cleaned and dry. Pre-treat with Dacrylate Mordant Solution ('T' Wash) (Ref.: 150-23). Normally applied over Vinadac MIO.
Galvanising (weathered): Wash down with detergent water and stiff brush to remove deposits of white zinc salts and road salts, etc., rinse, dry off. Degrease with Dacrylate Thinner R5 to remove any remaining oils, grease or other contaminants. Normally applied over Vinadac MIO.
Application Conditions: Temperature minimum 5°C
Humidity less than 90% RH
Application Methods: Brush: Apply using a 'full' wet brush. Avoid excessive 'brushing out' to maintain firm build. A wet film thickness of 190 microns will give a dry film thickness of 75 microns.
Roller: As for brush application, taking care to apply specified wet film thickness.
Spray: SB Acrylic Vinyl Sheen can be applied using conventional, airless and HVLP spray methods. 5-10% of Dacrylate Thinner R5 may be required to give optimum spray characteristics.
Brush or roller is the preferred method for use on damp surfaces.
Clean-up: Dacrylate Thinner R5.
Health and Safety: For more information request relevant Material Safety Datasheet.

The above information is general information on the product but without warranty. Since conditions of service and application are beyond our control we cannot accept claims for loss, damage etc., based on this information. Dacrylate will not accept any claim for consequential or incidental damages.

BBA     BCF     ISO 9001     Royal Society of Chemisty     HEA HEMSA     IPL     Business in the Community     PaintCare     Made in Britain     SEDEX - Supplier Ethical Data Exchange